ACS Mil Spec 1911

My other trader backed out so I have a Springfield Mil-Spec 1911 up for trade. It is stainless steel and has the following upgrades:

Bobbed Hammer and GI Grip Safety
Dehorn Sharp Edges
Blended Rear of Slide
Flush Cut Slide Stop
Harrison Design Short Trigger
Harrison Design Extended Mag Catch
Matte Bead Blasted
Upgraded to stainless, high quaility grip screws
Springfield Armory Installed a Range Officer barrel.

Upgraded internals to make a nice trigger pull:
1. Wilson Bullet-Proof Sear
2. Ed Brown Competition Mianspring
3. De-burred Mainspring Housing
4. Cut Hammer Hooks to proper height and squared
5.Harrison Design Short Trigger properly fitted.

Installed some custom grip tape as well!!!!! Lol.

This lock-up on the gun is very tight with little to no play in the slide-to-frame fit or barrel hood.

I also have a set of black wood grips if you prefer those over the brown grips. Gun only has about 300 rounds of Federal Ball and 20 Speer Gold Dots through it.

Gun will come with original hard case, holster, mag carrier, original take-off parts, and 2 quality 8 round magazines. I will also throw in an 10-8 National Match rear sight with the right deal and have a local gunsmith instal a dovetailed front sight for the right deal. Currently has the OEM sights.

Im looking to trade for an AR15.



This thing is a nice shooter. Here is an off-hand group at around 15 yards before the trigger job. Shot above red line was already there:



I really like this gun but would rather have an AR at this time.

 

Did you link the correct link?

 

Lol well at any rate I need the AR.

 

PM Sent

 

Traded