1911 Firearm Addicts banner
1 - 2 of 2 Posts

·
Registered
Joined
·
181 Posts
Discussion Starter · #1 ·
Hello guys,

Over 20 years I use cutting oil on Lathe and mill, have been thinking about getting coolant mister, question is does mist coolant will rust the machine and fixtures?

I really don’t like any rust on our machines and fixtures.

What brand do you guys use and system?

Pistolwrench, what do you have?

Thanks




Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
3,584 Posts
Rust should not be an issue as long as you use the proper fluids at the correct mix. Kool Mist and Trico are leading brands. You may want to look in to MQL - Minimum Quantity Lubricant units. They’re a little bit more expensive than mist in both unit and fluid but they run a lot cleaner. Accu-Lube and Unist are two names you can research.
 
  • Like
Reactions: jrjcp
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top