1911 Firearm Addicts banner
1 - 3 of 3 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter · #1 · (Edited)
I had a complete 1911 lower built for use with a few different uppers but just haven't used it much so I'm letting it go. It was built and hand-fitted by a well known smith in AZ using the following parts he selected:

- JEM stainless steel full size frame, checkered front strap
- JEM grip safety
- Cylinder and Slide parts (hammer, sear, trigger, disconnector, etc.)
- Colt sear spring
- Solid trigger
- Ed Brown stainless and checkered mainspring housing
- Ed Brown grips

This is a fully built and fitted 1911 lower frame ready to go with your upper. I was using it with a Nelson Customer conversion kit but other 1911 uppers will also work. I paid about $840 for it and haven't shot very many rounds through it--only a few trips to an indoor range. Trigger is smooth and shoots really well.

Asking $650 shipped to your FFL.

 
1 - 3 of 3 Posts
Top