First off I just had the maintenance done by Dillon last year. Replaced everything that was worn and it came back damn near new. And it has a lifetime warranty on it. As for what's with it: Roller handle and original handle Bullet holder Heavy Mount 7 toolheads: 5 regular and 2 short trim die (the two short trim toolheads have never been used) Conversion kits for: 9mm, .357/38, 45ACP, .223 Large pistol brass case feeder One powder measure with Large/Small throw bars Large primer and small primer tooling One large primer and one small primer pickup tubes Only thing you need to get going is dies. Have a set of Dillon .223 Carbide dies that have never been used I'll throw in for an additional $100. Also have a set of Dillon 45 ACP dies still in box that I'll sell for $65. $1,000 for everything. Does not come with the Allen Wrench set or Mr Bullet Feeder Local sell in Phoenix area preferred, but if I have to ship, I'll do so. I just have no idea what your cost of shipment will be. I will try to get a 650 box from Dillon to do the shipment.