Disassemble a frame: will it affect the trigger job?

Discussion in '1911 Gunsmithing' started by t0kie, Feb 12, 2012.

  1. t0kie

    t0kie Lock 'n Load

    241
    Nov 12, 2011
    I was thinking to do a refinishing to one of my 1911s & just wonder if disassembling the parts from the frame will affect a trigger job that is already done?

    If so, then I may not do it. Thanks in advance.
     
  2. Bender

    Bender Supporting Addict Supporting Addict

    Aug 15, 2011
    As long as the trigger shoe & bow channels are not effected, trigger pull will not be changed.
     

  3. t0kie

    t0kie Lock 'n Load

    241
    Nov 12, 2011
    So, you mean if I take them off & did not do any changes on those parts mentioned, then when I put everything back together it should stay the same?

    Thanks :)
     
  4. dilespla

    dilespla Never made it to step 12 Supporting Addict

    Oct 12, 2011
    You mentioned refinishing, are you refinishing the frame?
     
  5. EvolutionArmory

    EvolutionArmory Well-Known Member

    Sep 9, 2011
    Yes. I have taken my carry gun apart hundreds of times and I still have a glass rod trigger break.

    Depending on what finish you apply, you may need to smooth out the trigger channel and the frame where the sear and hammer go or ream out the pin holes. This applies to Cerakote or finishes like it (paint) but not to finishes like bluing or parkerizing.
     
  6. t0kie

    t0kie Lock 'n Load

    241
    Nov 12, 2011
    Yes, planning to do a cerakote or Black T (Birdsong) finish.
     

You need 3 posts to add links to your posts! This is used to prevent spam.

Verification:
Draft saved Draft deleted