1911 Firearm Addicts banner

1 - 4 of 4 Posts

·
I have many leather bound books
Joined
·
588 Posts
Discussion Starter #1
Does anyone have the chamfering tools to flush cut and reverse crown a 45 barrel?

I will pay shipping both ways and I can rent it from you too if that helps matters! Someone hook it up!
 

·
Dremel jockey
Joined
·
3,987 Posts
The tool that I use is a 16" x 40" engine lathe.
Weighs about 4500lbs.
Shipping might be expensive!

If I had one of the hand tools, I'd send it to you.
 

·
I have many leather bound books
Joined
·
588 Posts
Discussion Starter #4
The tool that I use is a 16" x 40" engine lathe.
Weighs about 4500lbs.
Shipping might be expensive!

If I had one of the hand tools, I'd send it to you.
Hahah thanks chuck! With those shipping costs it would probably be cheaper to drive to you! Hopefully someone will have one
 
1 - 4 of 4 Posts
Top