1911 Firearm Addicts banner

1 - 6 of 6 Posts

·
Registered
Joined
·
381 Posts
Discussion Starter #1
Greeting Gents,

I know this topic has been addressed here recently, so I ask you to bear with me..

I'm in line for a .38 Super build and in barely contained anticipation (I've always wanted a 38 Super), I am lining up reloading materials. I've ordered 500 rds of Starline Brass, Redding Titanium Carbide Dies and a Lee Taper Crimp. I use a single stage press, again for now, but might change at some point. The gun is going to be for range only and will probably be used in the occasional bowling pin or informal steel match. As such, I'm focused on potential accuracy more than power factor. I am going to focus my initial load development around the Hornady HAP 125 gr bullet. For initial powder testing, I'm thinking N350 or Power Pistol. Are there any potential pitfalls with setting up the 38 Super for my intended purpose anyone might be able to share? Any other accuracy load suggestions. Thanks in advance to and 38 Super zen masters out there.
 

·
I'm a terminal 1911 Addict!
Joined
·
5,065 Posts
I would PM @DukeSoprano
He has a boatload of Superb recipes.
 
  • Like
Reactions: Riflecrank

·
Registered
Joined
·
381 Posts
Discussion Starter #5
Thanks for the links! Looks like good reading!
 
1 - 6 of 6 Posts
Top