1911 Firearm Addicts banner

1 - 5 of 5 Posts

325 Posts
Discussion Starter #1 (Edited)


This gun was pulled from the factory line (Springfield Armory) and spec'ed for me for PPC Stock Auto in 2011.

factory adjustable rear sight Range Officer .45 and the following mods were done at the Springfield Armory Custom Shop in 2011:
  • SACS Tool steel action components set at 3.5 lbs,
  • Custom S&A Magwell that was drilled for a tight fit on the frame,
  • Magwell blended to the frame
  • Bottom checkering on magwell was removed for comfort,
  • Basic carry bevel job on the entire pistol (no sharp edges)
  • Flat black Armory Kote finish.

I paid over $1500 in this gun when new. I shot mainly target reloads in competition or in the state match....factory match ammo.

The factory wood stocks were never used....they are still brand new as I used pachmyrs for competition. Around 2500 rounds through the tube and this pistol was well cared for.

For a factory gun, slide to frame is tight. Barrel lockup is tight

Due to injury...I shot my last state match in 2014 and never got back into it. This gun has been sitting for 4+ years and I don't see me using it in the foreseeable future. I don't want to sell it as its accurate and reliable but I want someone else to enjoy it.

I did removed the front target sight and installed a Dawson fiber optic front. This gun was well taken care of, never an issue but it does have some very minor holster wear in some areas. I also put a minor dink on the front sight during install. It will take a serious stare to see the dink on the front side of the blade. It will not affect function.

Includes factory box, all papers, never used Springer plastic holster and mag holder, two factory magazines, replacement fiber optic rods.

Sell for $950 shipped w/insurance FFL2FFL US CONT ONLY

Not legal in Cali or if your state has specific model restrictions.

593 Posts
Funds and FFL information sent. And I'm all set. I have a Les Baer and this one as a back up. I'm officially back in the 1911 saddle again.
1 - 5 of 5 Posts