Looking for pictures of flush cuts and Crown cuts as I'm going to either have it done to my Clone or if Brownell's ever gets the tools in stock do it myself. Just don't know how deep I want to go. 11 degrees looks a little shallow and 45 degrees to deep. Suggestions?
Gatorshark
Thinking About Crown and Flush Cut.
For DIY, 11 degree and 45 degree is all you will find. If you want something in-between, you'll have to do it on a lathe
Crown and flush cut barrels always add class to a pistol, gives it a more finished look, good luck in your quest and make sure to post pics of your work.
Brownells sells the
Facing cutters BROWNELLS .750" Diameter 90 Facing Cutter Only SKU: 080586909
Chamfer cutters BROWNELLS 45 5/8" Chamfering Cutter Only SKU: 080588625
Brass pilots BROWNELLS .45 Muzzle Brass Pilot SKU: 080944450
and tap handle BROWNELLS FACING & CHAMFERING TOOL HANDLE
I don't use the handle, I just chuck mine up in a drill press and it takes me about 10 minutes to cut and crown, but some people like to do it by hand.
Facing cutters BROWNELLS .750" Diameter 90 Facing Cutter Only SKU: 080586909
Chamfer cutters BROWNELLS 45 5/8" Chamfering Cutter Only SKU: 080588625
Brass pilots BROWNELLS .45 Muzzle Brass Pilot SKU: 080944450
and tap handle BROWNELLS FACING & CHAMFERING TOOL HANDLE
I don't use the handle, I just chuck mine up in a drill press and it takes me about 10 minutes to cut and crown, but some people like to do it by hand.
Here's a .45 barrel I did with the 45 degree chamfer cutter from Brownells in my drill press for reference.
![Image]()
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
