1911 Firearm Addicts banner

1 - 5 of 5 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter #1
I have the P plate on the X300 and no way in hell with this slide on. This is the older X300, not the one with the screw on the side. This same light fit the TRP 1/2 rail fine, but the full rail is not having it. Any thoughts?
 

·
Registered
Joined
·
943 Posts
Do you have a “U” plate to try? I have the newer version with the side screw on my full rail and can’t remember how the older version was adjusted, other than there were two plates.
 

·
Registered
Joined
·
834 Posts
If it goes on, but won’t lock, Try the U. If it won’t even start on the rail, loosen the three small Allen screws on each side, slide on, then tighten the screws.
 

·
Registered
Joined
·
26 Posts
Discussion Starter #5
It won’t even begin to slide on. I removed both the rails and screwed the rails back in once it was positioned . It’s on there solid as f now, but removing it to change the batteries will be a pain in the balls. Not sure why this light went on my 1/2 rail fine, but won’t even start onto the full rail. Frustrating
 
1 - 5 of 5 Posts
Top