Not really practicing milling or anything, but I’ve got a gov’ 5” frame coming and need a slide for it. I’d also like to build a few others including a Commander. Mostly just want to get used to building them, and learning the fine tuning of 1911s.If you find some and don't need em all, I could use a few as well, mainly frames. Not sure what your need is, if your looking to build on or practice with. But, foster can be a good place for Caspian factory seconds at reasonable prices, and I've been able to procure some Sarco rough casted slides very cheap, but they are also just rough casted with no cuts at all. Come on handy for practice milling etc.. though.
I gotcha.. I need some for fixturing and cutting on lol.. Welcome to the Forum btw.. I probably missed your introduction.. You'll find this place to be full of some really top notch folks.Not really practicing milling or anything, but I’ve got a gov’ 5” frame coming and need a slide for it. I’d also like to build a few others including a Commander. Mostly just want to get used to building them, and learning the fine tuning of 1911s.
Dang. I was about to post an offering and stopped after that.I've got a legit Springfield Professional 45 upper...
I had planned on building it, but I'd let it go. View attachment 659321 View attachment 659323 View attachment 659325 View attachment 659327 View attachment 659329 View attachment 659331