Tried 1000 grit sand paper?

 

That is what I would do. Got a Kimber a few years ago, grips (G10 type) were a bit too aggressive for me. Does not take much sanding at all to soften them up just enough, comfortable, but still with plenty of grip.

 

This seller on Ebay makes Cordura fabric Combat Textiles grip wraps in various colors configurations for your Sig. WC modules too. Also makes and sells optic wraps. I've been very pleased.
SIG P365X/XL Grip / Wrap | eBay.

 

I actually went back to the factory module because of the Wilson module being extremely rough on my side while carrying the 365XL.


Sent from my iPad using Tapatalk

 

I actually went back to the factory module because of the Wilson module being extremely rough on my side while carrying the 365XL.


Sent from my iPad using Tapatalk

I've went From the Wilson and the aluminum modules back to the factory grip myself.

 

Some of my G10 1911 grips have had the left panel knocked down somewhat to smooth them so they don't abrade my side. (RH- IWB carry).

One of the reasons I truly love 20 LPI frontstrap & mainspring housing checkering is that the gripablity is stellar even when running smooth grip panels that carry easy.



I also have the WC module on my P365 and haven't noticed any issues.....yet. That being said I generally carry it in a pocket holster. I did pick up a WC module for an M18 (P320) that'll get IWB carry. A Dremel tool may very well be used if I run into issues.

Otherwise....love the feel of the WC grip modules.

 

Some of my G10 1911 grips have had the left panel knocked down somewhat to smooth them so they don't abrade my side. (RH- IWB carry).

One of the reasons I truly love 20 LPI frontstrap & mainspring housing checkering is that the gripablity is stellar even when running smooth grip panels that carry easy.



I also have the WC module on my P365 and haven't noticed any issues.....yet. That being said I generally carry it in a pocket holster. I did pick up a WC module for an M18 (P320) that'll get IWB carry. A Dremel tool may very well be used if I run into issues.

Otherwise....love the feel of the WC grip modules.

My Custom Colt Rail gun has 20lpi checkering and your right, it’s not moving in your hand while shooting, I love the Wilson grips as well and I think I will try the sand paper because after using the Wilson grip I can’t see myself going back to the stock Sig grip module.

 

WC should know better than that, WTH? I actually love the stock module on my P365X. I suppose if you had very large hands, it would be awkward for you.

 

The Sig isn’t bad by any means and I loved it until I got the Wilson.

 

I have the WC grip modules on my three 365's.

I had an issue with one of them being sharp on the sides of the back strap.

I swapped the module from my 365XL (I don't use it for concealed carry) to my EDC 365.

Sanding should do the trick. Lots of people have been doing that to polymer pistols for a long time.

Sent from my SM-G991U using Tapatalk

 

Ordered the Talon rubber grip today, I’ll update when it comes in and I’ve had a chance to try it out.

 

Finally got my Talon grips installed and they feel amazing and I think they look pretty good as well.